Quality Vision

Defect PREVENTION rather than defect detection.

Quality Goals

• Zero quality defect
• 100% on-time and first time approval for PPAP
  
• 100% on-time shipment
  

Quality Environment:

One challenge for us is to implement advance quality requirements in a low cost supply base without reversely affect the cost edge.

With experiences and skills from 5S, Lean, Six Sigma, TOC (Theory of Constraints), ACE, our team satisfies customer requirements from fields of QS/ISO 9001:2000, IATF 16949, AS 9100, ISO 14001, ISO 13485 etc. 

We implement a statistical analysis based environment to control and monitor the quality.  We do not wait to measure the result at the end, we "control" and measure it by day, by hour, by minute ... So by ensuring every step is correct, we have confidence to our output. We know we are right at beginning, in the middle, at any time...

• Effective PPAP with dynamic control plan
• DFMEA PFMEA in each part development and launching
• SPC Advanced statistical analytic capability CPK
• SCAR Corrective and Preventive Action Procedures, 8D 
• A comprehensive Calibration Program
• Traceability Procedures (Material and Manufacturing Lot)
• Incoming, In Process, and Final Inspection Procedures
• In Process Monitoring Procedures
• Nonconforming Material Procedures
• LEAN SIX SIGMA base Continuous Improvement Program

Our testing facilities include the following instruments:

• Spectrometer
• UT Machine
• Ultrasonic Testing Machine
• Impact Testing
• Profile Projector
• Metallurgical Microscope
• CMM
• Hardness Testing
• RT Film Viewer
• Water Washable DPT

Inspection Capability

Our inspection department is fully equipped with the latest equipment for measuring our products in process and when completed. These include:

• Caliper---tolerance：xx+/-0.02mm
• Micro-caliper ---xx+/-0.01mm
• Thread micro-meter----+/-0.01mm
• Caliper gauge--+/-0.01mm
• Pin gauge---+/-0.01mm
• Height gauge--+/-0.01mm
• CMM---+/-0.001mm
• Quadratic element ---+/-0.01mm